anyone with feedback and opinions on installing.

 

Yes. Everyone here has nothing but good things to say about them. I've ordered their burnout kit

 

no fitment issues, just take off your old stuff, and bolt in the new stuff. like all body panels, you just need to wiggle things into the right position before you tighten it down

 

what about removal of the front rebar? was anybody here able to avoid the removal?

 

I wonder how the quality is Vs. the original kit from KD-1

 

i needed to take that out for the feed front.

 

For the Burnout flares: Fitment was 8.5, finish was 8.5, quality 9.5. From what I understood from Ken during the first GB, the quality from the "Authentic" manufacturer was pretty crappy. Shine had to do a bit of reworking to make a proper mold.

 

yes thats true!

 

I recieved my shine/feed bumper in record time, I liked it so much that I should be receiving the rest to complete the car. They even customized the parts to the type of carbon that I specified. Thats service!

 

+100 I endorse Ken and Shine, they make great quality products

 

For the burn out front bumper, do you need to remove the rebar or just trim the turnsignal openings?

 

I don't have the front bumper but, if the rebar fits inside the bumper, all you need to do is modify the openings for the 99 signals. With my Mazdaspeed GTC bumper, I had to do this and everything mounted up properly.

 

I have the RE skirts from him, I wouldnt go anywhere else for body parts, besides the japanese tuners themselves. Take that back I went to raceonusa.com, good parts, fitment is alittle to be desired