Haltech wiring help
#1
Junior Member
Thread Starter
Join Date: Aug 2011
Location: Victoria bc
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
wiring help
wiring up my haltech sprint re just wondering exactialy how to wire up the ignitor im confused on how to wire the 12V source to coil and ignitor any help would be awesome thanks for all your help
#3
Junior Member
Thread Starter
Join Date: Aug 2011
Location: Victoria bc
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
I have a 13brew using stock coils and stock ignitor everything is in a fc with a painless type harness i am using stock 13brew connectors just need to figure out how to wire the ignitor.
thanks
thanks
#4
destroy, rebuild, repeat
iTrader: (1)
maybe this will help, its for e6x, but you can see how to wire it
http://www.tuningtechnology.net/Down...7_FD_Stock.pdf
the wiring isnt very simple, b/c you have to wire in the separate ignitor with FD coils. why not just use FC coils? or loose the waste spark and get 4 LS2 coils and get hotter spark
http://www.tuningtechnology.net/Down...7_FD_Stock.pdf
the wiring isnt very simple, b/c you have to wire in the separate ignitor with FD coils. why not just use FC coils? or loose the waste spark and get 4 LS2 coils and get hotter spark
#7
Junior Member
Thread Starter
Join Date: Aug 2011
Location: Victoria bc
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
using the stock fd coils figured it out T'd 12V into the black white wire for 12V coil supply that goes from ignitor to coil which turns to black red thanks everyone for your input. I was confused how the black white got power and then tore the old harness apart the factory did the exact same thing just T'd power into black white wire and it started.
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM