Haltech what's best for driveability; throttle pump or TPS correction map?
what's best for driveability; throttle pump or TPS correction map?
which do you guys use?
TPS correction map seems easier to adjust than throttle pump; it has less parameters to adjust.
TPS correction map seems easier to adjust than throttle pump; it has less parameters to adjust.
Do you mean TPS vs. Load Correction? this map is when you chose TPS as your main load source. The Throttle Pumps are a way to inject extra fuel into the motor when sudden movements of the throttle occur.
I messed with the throttle pump settings.
When I give gas softly, the engine revs fine. When I punch the gas, the engine stumbles and dies. IN the sensitivity map, I'm giving as much as 9 ms at lower TPS position and 5 ms at higher TPS position and it still behaves the same way. Throttle deadband is set at 6% (my TPS has a lot of noise even with the filter at max).
When I give gas softly, the engine revs fine. When I punch the gas, the engine stumbles and dies. IN the sensitivity map, I'm giving as much as 9 ms at lower TPS position and 5 ms at higher TPS position and it still behaves the same way. Throttle deadband is set at 6% (my TPS has a lot of noise even with the filter at max).
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
82streetracer
Haltech Forum
11
Mar 11, 2019 05:34 PM
befarrer
Microtech
3
Aug 22, 2015 05:52 PM
