Haltech Throttle calibrate question
#1
Open up! Search Warrant!
Thread Starter
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes
on
2 Posts
Throttle calibrate question
I went to calibrate the throttle and this is how it went. Under the throttle calibrate page with no throttle input, it reads 8%. It said same thing on engine data page. At full throttle it says 75% on both pages. I disconnected the throttle cable and rotated the throttle manually and it still says 75%. On the calibration page, it say to depress throttle and press space bar to continue.
Heres the questions: Should I depress the throttle, release it, then hit the space bar? Or should I hold the throttle down and hit the space bar while holding the throttle? After calibration, shouldn't it read 0% at no throttle input and 100% at full throttle? The sensor is mounted rock solid. The guy who did it has mounted them before and none of them have problems.
Thanks
Heres the questions: Should I depress the throttle, release it, then hit the space bar? Or should I hold the throttle down and hit the space bar while holding the throttle? After calibration, shouldn't it read 0% at no throttle input and 100% at full throttle? The sensor is mounted rock solid. The guy who did it has mounted them before and none of them have problems.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM