Haltech Stock Oil pressure to Haltech?
10-15-12, 08:57 PM
#27
fyi, the FC pressure sensor is just a pressure switch. doesnt actually detect more than one specific pressure.
at idle its supposed to see a specific pressure. anything less, it goes to zero. anything more, it goes to the determined range. unless its broken, then it goes to 0 or max.
then when pressure builds, trips the switch to make the needle go to the specific spot.
at idle its supposed to see a specific pressure. anything less, it goes to zero. anything more, it goes to the determined range. unless its broken, then it goes to 0 or max.
then when pressure builds, trips the switch to make the needle go to the specific spot.
Thread
Thread Starter
Forum
Replies
Last Post
