Haltech Some ?'s on hookin up E6K
#1
Senior Member
Thread Starter
Join Date: Aug 2001
Location: Tampa, Florida
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
Some ?'s on hookin up E6K
Do you need the factory igniter and relay for the coils? How do you hook up the oil sending unit/metering pump? Can you hook up the factory knock sensor or add another so you could have two? I'm a bit confused.
#2
Junior Member
Join Date: Sep 2002
Location: Gulf Coast
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
e6k setup
Hey rx7superman! I don't have an e6k, but I've learned alot about it in "studying" between the e6k & e11. I've pretty much decided on the e11 for my convertible turbo conversion.
To help you with some of your questions, from what I've seen the e6k does not control an electric OMP. But an e11 will. You'll still need the coil ignitor & relays. And I don't really see the point of two knock sensors. I think you could just hook up the stock one.
Again, I don't have a Haltech yet. But I definitely plan to get one. Most likely e11, because of the OMP management, Halwin software (not yet, but eventually available on e6k too), & other things. I'm not as knowledgeable as others on Haltechs. Just trying to help.
Do you have an e6k already, or thinking about it?
Later,
Stephen
To help you with some of your questions, from what I've seen the e6k does not control an electric OMP. But an e11 will. You'll still need the coil ignitor & relays. And I don't really see the point of two knock sensors. I think you could just hook up the stock one.
Again, I don't have a Haltech yet. But I definitely plan to get one. Most likely e11, because of the OMP management, Halwin software (not yet, but eventually available on e6k too), & other things. I'm not as knowledgeable as others on Haltechs. Just trying to help.
Do you have an e6k already, or thinking about it?
Later,
Stephen
#3
Senior Member
Thread Starter
Join Date: Aug 2001
Location: Tampa, Florida
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
I have the E6K and have all of it hooked up except for the omp, ignition coils/igniter/resistor and the knock sensor. I'm sort of stuck. So I'm trying to figure it out.
#4
Haltech E6K
Join Date: Feb 2001
Location: Northern California (USA)
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
What year car???
If you have an S6 you can find the wiring diagram on my site. If you have an S4 or S5 you can find the information on Hitmans website.
I believe you have an S4 or S5 because I do not know of any relay for the igntion coils/ignitor setup.
I believe you have an S4 or S5 because I do not know of any relay for the igntion coils/ignitor setup.
Thread
Thread Starter
Forum
Replies
Last Post
kamikazeRyan
Haltech Forum
6
12-23-01 11:42 AM