Hi, I'm using the stock FD water and air temp sensors (will get Haltech ones soon) but when I put in the calibration chart, it reads appropriate but when I exit halwin, turn the key off, and then reboot everything after saving my map, it goes back to the default haltech inputs.
These are the inputs I used as per one of the gurus here:
*C ------ Kohms
-40 ------ 25.525
-20 ------ 16.2
0 ------ 6.875
20 ------ 2.45
35 ------ 1.7575
50 ------ 1.065
65 ------ 0.6925
95 ------ 0

Any reason why my settings dont stay at that?