Haltech quick datalog question
08-22-05, 11:34 PM
#1
Cell Broadband Engine
Thread Starter
iTrader: (1)
Join Date: Aug 2003
Location: USA
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
quick datalog question
I noticed while viewing my datalog in offline mode, my water temp and air temps are in celsius, but in online mode while I was logging they were reading farenheit, does anybody know how I can change from celsius to farenheit while viewing them in offline mode?
thanks
thanks
08-23-05, 11:17 PM
#4
If you online and you are viewing datalogs, you will be using the format that your map was saved in. In your case imperial (US).
When offline, I think the software defaults to metric. So just run the software, press CTRL-M (Main Setup) and change the Units Setting to 'US' using the TAB key.
That should display your log with imperial units.
When offline, I think the software defaults to metric. So just run the software, press CTRL-M (Main Setup) and change the Units Setting to 'US' using the TAB key.
That should display your log with imperial units.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM