Haltech Ques. about wiring the coils..?
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Mar 2002
Location: bay area
Posts: 423
Likes: 0
Received 0 Likes
on
0 Posts
Ques. about wiring the coils..?
When connecting the flying lead to the coil(say leading coil), only one wire is used. What do i do with the other wire(car side) on the harness? do I disgard it or do i leave it attached to the harness?
thankss for the help!
thankss for the help!
Last edited by Gen2; 04-14-04 at 01:22 AM.
#2
I have a great write-up going on teamfc check it out man, see if that helps any.... http://www.teamfc3s.org/forum/showth...threadid=25806
#4
Senior Member
Thread Starter
iTrader: (3)
Join Date: Mar 2002
Location: bay area
Posts: 423
Likes: 0
Received 0 Likes
on
0 Posts
thanks for the help guys.
Rotarysc, your write-up answered my ques. However reading through it i came across this pic : . The wire labeled "Haltech Switched" connects to which wire from the lead?
Rotarysc, your write-up answered my ques. However reading through it i came across this pic : . The wire labeled "Haltech Switched" connects to which wire from the lead?
#5
its the black with yellow wire goes to the gray 12v switched ignition of the Haltech "power" harness.... the green with yellow wire is the wire used to the Haltech ignition harness.
#6
Open up! Search Warrant!
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes
on
2 Posts
I followed the instructions on this page for wiring the CAS and coils.
http://www.hitman.hm/installation.htm
http://www.hitman.hm/installation.htm
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM