When connecting the flying lead to the coil(say leading coil), only one wire is used. What do i do with the other wire(car side) on the harness? do I disgard it or do i leave it attached to the harness?

thankss for the help!

 

I have a great write-up going on teamfc check it out man, see if that helps any.... http://www.teamfc3s.org/forum/showth...threadid=25806

 

Haltech cannot fire directly into a coil, per se.
It needs an ignitior or something that simulates it.


-Ted

 

thanks for the help guys.

Rotarysc, your write-up answered my ques. However reading through it i came across this pic : . The wire labeled "Haltech Switched" connects to which wire from the lead?

 

its the black with yellow wire goes to the gray 12v switched ignition of the Haltech "power" harness.... the green with yellow wire is the wire used to the Haltech ignition harness.

 

I followed the instructions on this page for wiring the CAS and coils.

http://www.hitman.hm/installation.htm

 

Yup, my pictures and references are WRT Hitman's write-up.