Haltech Q: E11V2 settings for Autronic 500R CDI
Thread Starter
In rotor we trust!
Joined: Aug 2004
Posts: 258
Likes: 0
From: Moscow, Russia
Q: E11V2 settings for Autronic 500R CDI
Hi!
I bought a 500R and have a lot of questions.
Is a 500R falling edge?
Must I set an E11 in constant charge?
What the best charge time? My suggestion is 2.5 ms will be ok.
I have 4 crane cams LX92 also.
How I must twist coil wires (4 ve+ and 2 ve-).
Thanks.
I bought a 500R and have a lot of questions.
Is a 500R falling edge?
Must I set an E11 in constant charge?
What the best charge time? My suggestion is 2.5 ms will be ok.
I have 4 crane cams LX92 also.
How I must twist coil wires (4 ve+ and 2 ve-).
Thanks.
Senior Member
Joined: Aug 2001
Posts: 271
Likes: 0
From: Santa Barbara, CA
The 500R is falling edge. Did you buy your ignition used? All of the Autronic products are dealer supported; if you bought it new, you should contact the dealer you purchased it from for this type of information.
Thread Starter
In rotor we trust!
Joined: Aug 2004
Posts: 258
Likes: 0
From: Moscow, Russia
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
rx8volks
Canadian Forum
0
Aug 13, 2015 04:55 AM
