No_Rotor_RX7

F10x trouble...

so a couple days ago i was able to get the car to start almost every time. i achieved this by adding a ton of fuel in to the priming map. once cranked it would stay running without an issue.

i didn't get to do any more than that and i haven't been able to mess with it until now. i go out there and it wouldn't crank the first few times i tried. then on maybe the 3rd or 4th try it fired off then shut down. (this is all without touching the gas pedal). now, it won't crank up at all.

i pulled the plugs, they are not wet but i was smelling fuel for a minute there. turned it over with the injectors off and the plugs out. no fuel smoke came out... very nice solid puffs (compression is great, this thing used to fire up first try on the carb setup everytime hot or cold)

anywho, i've been adjusting the priming map in all different ways and no change. all fuses check out, fuel pump comes on every time.. i'm lost.

i started from scratch so maybe i did something wrong? i've built a few maps but not for a bridgeported motor before.. i've only done boost tuning on a large port setup like this.

can i get a solid basemap for an F10x from someone? or can i send my current base map to someone and get the cranking adjusted? hahaha

thanks everyone, im trying to get this thing on the dyno this weekend if possible

No_Rotor_RX7

ok, i guess it really does just want that much fuel! OMFG it's rediculous! either way i have the idle set pretty well and it starts up the first try 2 out of 3 times... weird i tell ya.