Haltech LS1 coil diagram for e6k
#2
Mad Man
iTrader: (5)
Check this thread out for more information on the coil pinouts
https://www.rx7club.com/showthread.p...&highlight=ls1
Leading gets branched to the the two leading coil inputs, Trailing outputs go to their respective coil
The stock igniter is not used, outputs come directly from the haltech.
https://www.rx7club.com/showthread.p...&highlight=ls1
Leading gets branched to the the two leading coil inputs, Trailing outputs go to their respective coil
The stock igniter is not used, outputs come directly from the haltech.
Last edited by fritts; 10-27-08 at 10:43 AM.
#3
EFI Tech Wannabe
iTrader: (1)
Join Date: Sep 2003
Location: D.R., USA, the world...
Posts: 2,405
Likes: 0
Received 4 Likes
on
4 Posts
You dont use the stock igniter as Fritts pointed out. With E6K in direct fire you will connect Ign.Out to both Leading coils, Dig1 to T1 and Dig2 to T2. Searching is your friend use it.
Thread
Thread Starter
Forum
Replies
Last Post
windom
Adaptronic Engine Mgmt - AUS
4
09-11-15 04:48 AM