Long story short https://www.rx7club.com/adaptronic-e...1129936/page2/ post 72

So I'm looking at the Haltech elite 1500. That should be plently for my needs. Going to get 2x 150psi pressure sensors, fuel/oil. Also Oil temp and new water temp sensor. TCA2 for EGT's and the onboard wideband. Also looking at getting 2 of the haltech multi-function gauges. For the gauges and the TCA2 would I need the 4 port can hub?

My big thing is do I just use my engine harness and get the pnp model or get a good quality harness made or get one of the harness from haltech? My harness is in good shape but could be better i guess. is there anything else I should be thinking of?


Streetported 13brew
FFE fuel rail ID850 pri / ID2200 sec
FFE 36-1 trigger
BW EFR8374 IWG
Sakebomb aem IGN1 coils direct fire

omp, ac, all emissions deleted

Thanks
Carl

 

Chris at LMS efi can answer all of your questions, and is a haltech retailer. He can build custom
harnesses, sells everything you’re looking for, and offers top notch customer support.

 

The guages piggy back off each other and the CAN wideband. There's two CAN outputs, one on the ECU housing itself and one can be wired in with the harness, so if you're only doing the wideband w/ guages and the TC2, you should be good. However, I don't know **** so ask Chris. Lol

 

Carl,

If you still need any of these parts (injectors, coils, coil bracket, etc), I'll be able to help with that. We need to talk about fuel filtration (Injector Dynamics F750) to protect those sensitive injectors as well as a Fuel Pressure Damper (Radium FPD-XR). Especially when running premix, it's an incredibly common oversight. About to start doing my m22579/32 coil harnesses once I see where everyone is mounting their setups.

Here for whatever you need.

-Ryan

 

Very wise upgrade, you'll be happy with the change. PM me when you get it in and we can work you out a custom basemap and try to make back as much of your time that adaptronic wasted as possible.

Skeese