Haltech IQ3 Tach Bar Setup
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: May 2010
Location: Santiago, Chile
Posts: 373
Likes: 0
Received 0 Likes
on
0 Posts
IQ3 Tach Bar Setup
Guys,
My Non Log IQ3 shows only 8000 RPM as max value on the Tach Bar on top of the display.
I tried this setup
subir imagenes
Min Value: 0
Max Value: 9000
Tag Start: 0
Tag Value: 1
Bar keeps showing only 8 (8000 RPM) as maximum value.
Am I doing someting wrong ?? I´ll probably get the car to 8500 RPM Max so would be nice to see a 0 to 9 RPM Bar.
Thanks..!!
CC
My Non Log IQ3 shows only 8000 RPM as max value on the Tach Bar on top of the display.
I tried this setup
subir imagenes
Min Value: 0
Max Value: 9000
Tag Start: 0
Tag Value: 1
Bar keeps showing only 8 (8000 RPM) as maximum value.
Am I doing someting wrong ?? I´ll probably get the car to 8500 RPM Max so would be nice to see a 0 to 9 RPM Bar.
Thanks..!!
CC
#2
www.lms-efi.com
iTrader: (27)
Change the tag value per bar and tag start values. The tags are the numerals on the bar graph. So, for instance I tune a car that is shifted at 10500 and I want max resolution between 6000 and 11000. So I make the first tag 3, for 3000, and tag value is set to 1, so each tag increments up by 1. The display then reads 3, 4, 5, 6, 7, 8, 9, 10, 11. Make sense?
You don't want a 0 value. There is a 0 by default at the bottom of the graph. So use start tag 1 and tag value 1 and you'll have 1000-9000 displayed.
You don't want a 0 value. There is a 0 by default at the bottom of the graph. So use start tag 1 and tag value 1 and you'll have 1000-9000 displayed.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM