Hey.

The Haltech manual says that the wire that needs to go to all four injectors is red. There is no red wire in my loom for the injectors. There is a lower-gauge red/teal wire. Is this the one? I am pretty sure it is, but I want to be sure.

Secondly, what's the best way to splice that wire (assuming it's the correct one) to all four injectors?

Thanks,
Victor

 

It's usually red & green, and thicker gauge than the others.

you have to splice 4 wires into it (solder them together) it can be tricky to do, what I usually do is strip them all then bundle the 4 around the one from the haltech loom, like the 5 side of a dice.

then take a strand of copper wire and twist it around the bundle like a twist tie, this is, of course, after tinning all the wires.

the copper holds them together while i solder the whole bunch together.... make sure you have the heat shrink upstream before you solder it too

good luck.

 

teal, green, whatever.

thanks a lot, pengarufoo.