Now that I got my NA 20b starting and idling pretty well, I was curious as to the injector current settings when I eventually upgrade to larger secondarys? Currently I'm using stock 550cc primary and secondary injectors. I had both sets cleaned and flow tested at Witch-Hunter. They measured the resistance at 13.4-13.5 ohms on all 6. My ohm meter showed closer to 14ohms so I have my current setting on the lowest setting on the Haltech. Anyways, all the larger injectors that I've been searching for are showing 3-4 ohms. My E11v2 sets the injector current the same for injectors 1-6 soooooo, how would I go about correctly adjusting the current to those injectors since they are much lower?

 

Set it up for the low ohm injectors. It'll be fine.

 

Just what I wanted to hear thx!