Haltech generic load/pwm map
#1
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
generic load/pwm map
I have my meth solenoid on pwm 2. When i adjust the map i need to turn off/on the ecu before the changes effect. I never saw anything about this in the manual. Is there something wrong with my ecu or is this normal
#2
Rotary Reborn!
iTrader: (3)
I had the same problem with my staging map before I reloaded with the new firmware.
Also you have to enter the valve into the cell. You cannot just type it in then select the the next cell.
Last resort reload your firmware. Load base map supplied by haltech and then load your modified map.
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM