Hi guys. Need some help please,
I have a PS1000 with pluginharness in my FD and now i have ordered a haltech iq3dash and the can wideband 02sensor.
That means i have to get a can hub to but will it be enough with the mini 3port version?

Im also planning on connecting some sensors for the dash, oiltemp/press, fuelpress and one EGT..
So have i got enough avis in my haltech for those?
Im not using the stock o2 or the OMP can those be used for spare sensor inputs??

 

Tony, I use the oem O2 input for my wideband sensor so that is fully doable

about the OMP thou I'm not so sure about since it is outputs in the ECU, not inputs

 

I ran my wide band with the oem 02 input, and ran my iq3 dash and Dual EGT thru the mini can hub, I'm also running the flex fuel sensor, oil press, fuel press, oil temp sensor on my PS1000, so you should be good.

 

Since im going to use haltechs can wideband and the iq3 the minihub will be filled with that.
And if I have an egt Thermocouple Amplifier to get 0-5volts then thats the same number of sensors youre running.
So I should have enough inputs in my ps1000?

 

The Sport 1000 has 4 AVIs and there's only 1 used for the position signal from the OMP on S5 and S6 PnP looms. If you look at the maps for S5 and S6 for the Sport 1000 in the ECU Manager software you can see you have 3 AVIs available.

The only thing to watch out for would be that those functions will not be pinned on the harness. So you will need to order pins from Haltech to get these signals activated.

 

Thanks..

Where can I find good quality sensors for resonable money? The haltech ones are pretty expensive and ffe couldnt deliver any right now..