Haltech E8 and FC S5 stock vehicle harness question
E8 and FC S5 stock vehicle harness question
Besides disconnecting each wire or sensor, is there a way to know what wires, sensors, useless stuff I can eliminate from my harness?
I am running E8 and my stock instrument cluster(Only way I know of to keep an eye on fuel levels).
The dash and vehicle have been 100% gutted. Stock fuel tank, but upgraded pump. Nothing under the dash attached to the firewall(blowers, a/c. heaters, etc.)
I put the s5 harness in but want to eliminate as much as possible to make it less cluttered and more maneable.
Thanks for any input
I am running E8 and my stock instrument cluster(Only way I know of to keep an eye on fuel levels).
The dash and vehicle have been 100% gutted. Stock fuel tank, but upgraded pump. Nothing under the dash attached to the firewall(blowers, a/c. heaters, etc.)
I put the s5 harness in but want to eliminate as much as possible to make it less cluttered and more maneable.
Thanks for any input
Rotary Enthusiast
Joined: Aug 2004
Posts: 1,326
Likes: 9
From: Australia - Perth
lol stop being slack and pull the harness apart 
Ibe got the same, took me about a month on and off to full rewire everything and remove all the wiring I didnt need. (Im also running a E8)
Was a ***** of a job but worth it. Also I didnt do the plug and play I used a new E8 harness as I didnt want any issues
Ibe got the same, took me about a month on and off to full rewire everything and remove all the wiring I didnt need. (Im also running a E8)
Was a ***** of a job but worth it. Also I didnt do the plug and play I used a new E8 harness as I didnt want any issues
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
Aug 26, 2015 09:52 PM
