Haltech E8 data log.
#1
Rotary Enthusiast
Thread Starter
E8 data log.
Guys after some help.
My engine let go last night. Rear rotor has no compression.
I know the E8 has onboard data logging but it was set to single pass...
So does this mean I could potentially have no data of the engine failure... as this date would be from 12 months back ?
Is there any way i can get the data from last night ? (and no the laptop was not hooked up..)
Thanks for any assisatance !! I never knew their wa bloody settings inside the onboard logging !!
-Anth
My engine let go last night. Rear rotor has no compression.
I know the E8 has onboard data logging but it was set to single pass...
So does this mean I could potentially have no data of the engine failure... as this date would be from 12 months back ?
Is there any way i can get the data from last night ? (and no the laptop was not hooked up..)
Thanks for any assisatance !! I never knew their wa bloody settings inside the onboard logging !!
-Anth
#5
Rotary Enthusiast
Thread Starter
#6
Rotary Enthusiast
Thread Starter
Na bumps, same tune that I've had going for the past year and a bit. been sitting at that 350 hp at 12psi the whole time.
Nothing out of the ordinary, just let o by the sounds of it.
I kinda wish I was driving when it died though. The mechanic mate who was driving felt like **** he had killed it.
all good if I cant use that data, then I'll know to have it on loop mode for the next block that for sure !! (kinda wish I had read up on that more now !!)
Nothing out of the ordinary, just let o by the sounds of it.
I kinda wish I was driving when it died though. The mechanic mate who was driving felt like **** he had killed it.
all good if I cant use that data, then I'll know to have it on loop mode for the next block that for sure !! (kinda wish I had read up on that more now !!)
Thread
Thread Starter
Forum
Replies
Last Post
BLUE TII
Single Turbo RX-7's
10
09-26-15 10:12 PM