Haltech E6X O2 sensor !!!
#1
Full Member
Thread Starter
iTrader: (1)
Join Date: Apr 2007
Location: Montreal
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
E6X O2 sensor !!!
Hi guys !!!
I need to know how to connect the Haltech wire to my O2 Sensor 4 wire please. The O2 Sensor is the one who is on the Downpipe close of the turbo.
Thanks !!!!
I need to know how to connect the Haltech wire to my O2 Sensor 4 wire please. The O2 Sensor is the one who is on the Downpipe close of the turbo.
Thanks !!!!
#3
destroy, rebuild, repeat
iTrader: (1)
Do you already have a wideband lower down in the downpipe? if your wb controller has a 0-5V output, you could just wire that up to the haltech, and you should be able to do closed loop with it. then you wouldnt need the other o2 sensor
The other option would be to just replace your 4-wire with a stock narrowband o2 (single-wire) and wire it to the haltech o2 sensor input
The other option would be to just replace your 4-wire with a stock narrowband o2 (single-wire) and wire it to the haltech o2 sensor input
#5
Full Member
Thread Starter
iTrader: (1)
Join Date: Apr 2007
Location: Montreal
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Hey hey gxl90rx7 I need you again :P !!
Do you know what is the tachometer wire because my tachometer was **** top when I push the gaz... at 1000rpm it goes to 2500rpm in one shot...
I don't know what is the wire and where it go. I think is go on the Leading and trailing coil ... ?!?!
Thanks a lot for your help !!!
Do you know what is the tachometer wire because my tachometer was **** top when I push the gaz... at 1000rpm it goes to 2500rpm in one shot...
I don't know what is the wire and where it go. I think is go on the Leading and trailing coil ... ?!?!
Thanks a lot for your help !!!
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM
rotor_veux
2nd Generation Specific (1986-1992)
7
09-19-15 07:13 PM