Hooking up an E6K (welcome to 2002 right?) And i'm having trouble turning the ECU on. It's getting +12v to pin 25(red/white) and both grounds are grounded....where the heck does the switched power tie in? Maybe i'm blind...but on the e6k wiring diagram I don't see any grey/switched power for the ECU plug itself.

 

does this help you?
http://www.docstoc.com/docs/26736448...ing-Diagramcdr
I punch in E6k and get E6x...go figure,but it shows wiring.

 

Pin 7 for the E6X looks like it has a different function than on the E6K. I have switched power hitting 25 and nothing else. Is that all that's required at the ECU itself? If so then I have a different problem keeping me from connecting.

 

do you have the power and fuel relays installed ? a 87 30 85 86 relay .

Switched 12 v goes from source split to both relays ( tab 85 on relays )

 

Figured it out...didn't have dosbox configured properly.