Haltech E11v2 ignition output - ground or 5v?
Thread Starter
Joined: Aug 2001
Posts: 1,115
Likes: 0
From: Santa Monica, CA
E11v2 ignition output - ground or 5v?
I was reading this thread here on the AEM forum: http://forum.aempower.com/forum/inde...c,15347.0.html regarding using LS2 /7 coils (instead of LS1 coils).
It appears that the LS2 coils use a 5v square wave instead of a ground on/off square wave to fire that the LS1 coils use. Can this be set somewhere on the E11v2? I'm assuming that the usual setting is ground as the LS1 coils work fine.
It appears that the LS2 coils use a 5v square wave instead of a ground on/off square wave to fire that the LS1 coils use. Can this be set somewhere on the E11v2? I'm assuming that the usual setting is ground as the LS1 coils work fine.
Thread
Thread Starter
Forum
Replies
Last Post
