E11v2 ignition output - ground or 5v?
 

I was reading this thread here on the AEM forum: http://forum.aempower.com/forum/inde...c,15347.0.html regarding using LS2 /7 coils (instead of LS1 coils).

It appears that the LS2 coils use a 5v square wave instead of a ground on/off square wave to fire that the LS1 coils use. Can this be set somewhere on the E11v2? I'm assuming that the usual setting is ground as the LS1 coils work fine.

NM, this appears to be taken care of by the Falling or Rising edge setting!