Haltech Crank Trigger wiring on a E6A
Thread Starter
OLDROTA
Joined: Apr 2003
Posts: 1,389
Likes: 2
From: Los Angeles
Crank Trigger wiring on a E6A
Anyone know which wires go where from the crank trigger to the signal stabaliezers. I can't get help from Haltech au for some reason. Anyway...here's my setup:
I'm running the 3 bosch ignitors and all that **** but this is my problem. The computer runs 2 MSD signal stabalizers, one L and one T, both have purple and green wires that go to the 4 wires of the crank trigger connection. I NEED THIS CONNECTION INFO. From what color crank trigger wire to which box purple and green? Even a simple idea from the 4 prong connector (i.e. top left, bottom left, etc.)
I hope this makes sense to someone....
I'm running the 3 bosch ignitors and all that **** but this is my problem. The computer runs 2 MSD signal stabalizers, one L and one T, both have purple and green wires that go to the 4 wires of the crank trigger connection. I NEED THIS CONNECTION INFO. From what color crank trigger wire to which box purple and green? Even a simple idea from the 4 prong connector (i.e. top left, bottom left, etc.)
I hope this makes sense to someone....
Rotary Enthusiast
Joined: Apr 2001
Posts: 1,289
Likes: 0
From: North Hollywood, Ca USA
sorry, I never saved this info as I was unable to get it to work. email to Haltech should get the info. best to look into fabricating a chopper wheel and pick up mount. again sorry I don't have the info, but at the time I was not interested in how it should work.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
Sep 11, 2015 03:29 PM
windom
Adaptronic Engine Mgmt - AUS
4
Sep 11, 2015 04:48 AM
