I just bought an E6K from someone and the serial connector on the Haltech harness was damaged. There are only 4 wires inside the connector from the Haltech. The green one was ripped from the connector and I do not know which terminal it was from. Inside the connector, the terminals are numbered. The connector comes apart w/ just 2 screws.

I think this is how they are supposed to be
1: nothing
2: red
3: blue
4: green?????
5: yellow
6 through 9: nothing

If anybody can verify this I would really really appreciate it, I know it is an odd request. I spliced in another serial cable, but would really like to be sure before I hook it up to my laptop.

Thanks
Mike

 

Today I noticed the connector is included in the wiring diagram. Pin 4 is not used. Not sure what the green wire is doing inside there then but I guess I'll be okay.

 

If I remember correctly, only two of the wires are used.
TX and RX?

I have my notes back at home - at work right now.


-Ted

 

On the E6K(Also X) the only pins you need be concerned with are as follows:

HALTECH -------- DB9 RS232 9Pin

Pin 8 ------------------- Pin 2(TX)
Pin 9 ------------------- Pin 3(RX)
Pin 26------------------ Pin 5(Ground)

Check for continuity across these wires, and you should be all set.