Haltech boost controller ???
#1
yes,thats me \/
Thread Starter
iTrader: (1)
Join Date: Mar 2006
Location: Eaton, CO
Posts: 861
Likes: 0
Received 0 Likes
on
0 Posts
boost controller ???
i am kind of confused how to wire up the boost control solenoid. there is two wires, what do i wire them to? i looked in the manual and it wasnt clear to me.
#2
EFI Tech Wannabe
iTrader: (1)
Join Date: Sep 2003
Location: D.R., USA, the world...
Posts: 2,405
Likes: 0
Received 4 Likes
on
4 Posts
Originally Posted by cdaleracer669
i am kind of confused how to wire up the boost control solenoid. there is two wires, what do i wire them to? i looked in the manual and it wasnt clear to me.
#4
EFI Tech Wannabe
iTrader: (1)
Join Date: Sep 2003
Location: D.R., USA, the world...
Posts: 2,405
Likes: 0
Received 4 Likes
on
4 Posts
Originally Posted by cdaleracer669
alright i wasnt sure what the "other " wire went to (12 volt power). thanks. it is the e6k
#5
Crash Auto?Fix Auto.
iTrader: (3)
Bringing this back....
Where is a good "starting point" for the wastegate duty cycle map? Should it just be flatlining at a given voltage? If so, what voltage?
Just trying to set this up so the first time I boost on the haltech EBC I don't end up jamming 25 psi down my engine's throat....ya know
Where is a good "starting point" for the wastegate duty cycle map? Should it just be flatlining at a given voltage? If so, what voltage?
Just trying to set this up so the first time I boost on the haltech EBC I don't end up jamming 25 psi down my engine's throat....ya know
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM