Haltech Air temp sensor.
Air temp sensor.
Oh hey it's me again.
Is there a haltech sensor or equivalent that is a direct replacement for the stick one? Such as the 14MM in haltech has. P# HAL HT010200?
Thanks a lot fella's!
Is there a haltech sensor or equivalent that is a direct replacement for the stick one? Such as the 14MM in haltech has. P# HAL HT010200?
Thanks a lot fella's!
No. Not for the FC or FD.
The wannaspeed.com sensor will be a direct fit to the FD manifold, but the calibration is not the same as the GM/Haltech calibration. You'll need to do a custom calibration for that sensor.
The wannaspeed.com sensor will be a direct fit to the FD manifold, but the calibration is not the same as the GM/Haltech calibration. You'll need to do a custom calibration for that sensor.
Last edited by C. Ludwig; Aug 3, 2011 at 12:04 PM.
I would/do use the 3/8 NPT sensor. That way I know the calibration is correct. It's a 10 minute operation to drill and tap the throttle body elbow once you have it off the engine.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
