Why wont it go into gear?
#1
Junior Member
Thread Starter
Join Date: Mar 2004
Location: Salem, IN
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Why wont it go into gear?
Ok i dont know what the hell happened but my car will not go into gear , i havent a clue of what to do, but im guessing somethings wrong with the clutch. If anybody has had this experience , and knows whats wrong, if you would please help me out!!
Thanks JCraig
Thanks JCraig
#4
yea i had that problem, if it goes into gear with the car off and not when running the clutch isnt releasing, this can be a broken clutch/ pressure plate and or a the slave (as stated above) isnt releasing the clutch. mine was the slave leaking an me not reafilling the resivor, and have someone press the clutch pedal in while you look at the top of the tranny and see if the slave moves the fork, it if dont thats the problem
#5
multipersonality disorder
Join Date: Feb 2002
Location: so. cal
Posts: 5,656
Likes: 0
Received 0 Likes
on
0 Posts
check to see that the clutch fork moves when the clutch is applied. if it does, you problem may lie within the clutch assembly itself.
if it doesn't move, then the master and slave cylinder are the next reasonable things to check.
if it doesn't move, then the master and slave cylinder are the next reasonable things to check.
#6
Inspector, Falcon Jet
Join Date: Mar 2003
Location: Little Rock
Posts: 430
Likes: 0
Received 0 Likes
on
0 Posts
Will it go in gear with the engine not running? If so, the problem is the transmission input shaft and the pilot bearing are siezed up in the ecentric shaft, which causes the gears to be spinning all the time, to fast for the syncros the allow the gear to engage
Last edited by rototiller1; 06-06-04 at 02:29 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
MILOS7
3rd Generation Specific (1993-2002)
2
10-09-15 02:19 AM