Starting problems after rebuild
#1
Junior Member
Thread Starter
Join Date: Apr 2007
Location: Germany
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Starting problems after rebuild
Hi, I did a rebuild on my 13b engine. now it wont start up anymore. die very first start after the rebuild was fine. it started. yesterday nothing. i filled some oil into the sparkplug-holes. it worked.
today the same thing.
the engine went about 218 miles till yet.
now there is nothing happining anymore.
please, I need tech support
Best regards
today the same thing.
the engine went about 218 miles till yet.
now there is nothing happining anymore.
please, I need tech support
Best regards
#2
Rotary Loco
Hello rx7_ger
Sorry to hear about your engine problem, I know how fustrating could be,
Am not expert but I will recommend a compression test to see if the apexs are holding compression.
That should give you an ideas if is internal problems, stuck seals......
Andres
Sorry to hear about your engine problem, I know how fustrating could be,
Am not expert but I will recommend a compression test to see if the apexs are holding compression.
That should give you an ideas if is internal problems, stuck seals......
Andres
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM