Spun a Bearing

Reply Subscribe

Thread Tools

Search this Thread

May 25, 2008 | 08:15 PM

dvs71990

Thread Starter

Senior Member

Joined: Sep 2007

Posts: 542

Likes: 0

From: New York

Spun a Bearing

I spun a bearing due to no oil pressure. I cant get the rotor off the e shaft, what should i do?

May 25, 2008 | 08:44 PM

Rocking Rotary

Rotary Enthusiast

iTrader: (14)

Joined: Aug 2002

Posts: 1,482

Likes: 3

From: St. Paul, MN

Hit it with a block of wood or a dead blow mallet.

Jun 2, 2008 | 09:32 AM

Whizbang

Respecognize!

Joined: Sep 2004

Posts: 4,106

Likes: 72

From: Anchor Bay, CA

Since the eshaft is probably done for. Get your self some wood, about three pieces, to support the rotor. Get this at enough high where eshaft is suspended (a press is great for this) then hammer the shaft out.

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

n/a transmission rebuild

Vartok

2nd Generation Specific (1986-1992)

Oct 8, 2015 04:49 PM

84SE Engine Swap Success! Surge at idle, clutch out.

LongDuck

1st Generation Specific (1979-1985)

Oct 7, 2015 08:12 PM

Reply Share

First
Prev
1 / 1
Next
Last