Hey everyone,

Anyone have any experience with speedhut fuel level gauges and senders? I am wanting to run their fuel level gauge to accompany my racepak. I plan on running premix with the FD and was wondering if it would be harmful to the sender, I tried reaching out to them directly but have yet to receive a reply. Does anyone here have any experience with their fuel level gauges? Any help would be appreciated.

 

I am waiting on my gauges, but i understand they work with the stock sender. I dont think you can damage the sender with pre mix.

 

I have the speed hut gauge and sender .... no worries. it will work fine with or without pre mix

 

What length do you need to mount it in place of the stock sender in a stock FD tank?

 

not sure bro... im old school... rx3

 

u really should be asking this in the 3rd gen specific section.

 

Where do you plan putting it? As long as is in the same car, it ahouldnt mater much. I dont think thats too long of a distance dor the signal to fade put that bad. Dont worry too much about that. Just wire ot properly and it should be good.

 

I don't mean for the wiring, I mean the post that actually sits vertically in your gas tank and measures the fuel level. They offer a range from 3.5" to 12"

 

I don't think you'll damage it.