Hey im making my FD a single turbo it has a bridge port done and running microtech i will be doing fuel soon but I am wondering what is a safe boost level to run on a 13b I would like to run high boost but dont want to blow it.. I am new to rotarys so any info would help thanks

 

it depends on the fuel you run and if you run some sort of auxillary injection.

 

I will be running regular pump gas 93 octang , mods are 13b bridge port, microtech, 3 inch down pipe, full exaust, testpipe, ad a intake.... the setup i will be running is going to be a t-78 or mostlikey turbonetics 60-1 , HKS Intake,High Flow Throttle Body,Alum. Fly Wheel,hks waste gate and deciding on what kinda intercooler and pipes id like to run and im stuck on fuel this car is going to be a street car but not an everyday driver so and other info would be helpfull thanks

 

opps

 

if u go the T78 rout or the 60-1 ur gonna need a 3row intercooler. as far as fuel Bridge port i wold say 850 and 1600 for injectors and dont get the HKS Wastgate here is the write up
https://www.rx7club.com/single-turbo-rx-7s-23/those-hks-log-mani-40mm-gates-588641/

 

if you only run 93oct and no auxillary injection you really shouldnt chance running more than 15-17psi.

 

What do you mean by auxillary injection like a watter or water alcohol injection???

 

yep

 

any other sugestions on anyhitng elts id like to get in the low to mid 20psi but run safely

 

ignition upgrade. all other supporting mods. my sig is just brushing the surface of all mods needed for single turbo.

 

forgot map sensor