single turbo conversion and solenoid valve issue
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: May 2009
Location: greece
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
single turbo conversion and solenoid valve issue
hi Guys,
a few months ago i made the conversion to single turbo. now i want to remove the unesesary solenoid valves .
my questions are :
1) if i disconnect the solenoids , will i get an error code from the ecu? i run the stock ecu. is this a problem ? (if the ecu returns error codes ) can i ignore them ?
2)some connectors needs to be changed because they are in very bad condition. where can i buy these type of connectors?
3)can i do something to protect my harness and connectors? is there a kind of tape i can use ?
4) i am fiting an aeromotive fuel presure regulator. do anny of you guys have any tip?
thanks for all your help. i wish i had discoverd this site long ago!!!
achilles
a few months ago i made the conversion to single turbo. now i want to remove the unesesary solenoid valves .
my questions are :
1) if i disconnect the solenoids , will i get an error code from the ecu? i run the stock ecu. is this a problem ? (if the ecu returns error codes ) can i ignore them ?
2)some connectors needs to be changed because they are in very bad condition. where can i buy these type of connectors?
3)can i do something to protect my harness and connectors? is there a kind of tape i can use ?
4) i am fiting an aeromotive fuel presure regulator. do anny of you guys have any tip?
thanks for all your help. i wish i had discoverd this site long ago!!!
achilles
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM