Rotor Housing groove spec
09-23-15, 12:11 AM
#1
Rotor Housing groove spec
Is there an actual spec to the amount of grooving allowed on the edge of the rotor housing?
I can catch a fingernail on it but there is no real flaking going on. The FSM says check for flaking and the overall thickness but doesn't reference any measurement for flatness of where the apex seal rides.
I can catch a fingernail on it but there is no real flaking going on. The FSM says check for flaking and the overall thickness but doesn't reference any measurement for flatness of where the apex seal rides.
Thread
Thread Starter
Forum
Replies
Last Post
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM