Hello Guys,
I'm in the process of tearing down a engine I purchased at the junkyard. I forgot to remove the 19mm pulley bolt. So after tearing half the engine apart. I got to the middle iron and I could not remove it due to the fact that the pulley was still on. I tried re attaching the flywheel bolt back on to use a leverage but no dice. I don't have a air compressor so that's out. I also, tried to heat the bolt to no avail.

 

here is the tool for you to remove it. Cost about 25 shipped:

http://www.mazdatrix.com/toolmisc.htm

But it will SAVE YOU ALOT OF strength =D Good luck.

-AzEKnightz

 

here is the tool for you to remove it. Cost about 25 shipped:

http://www.mazdatrix.com/toolmisc.htm

Use this tool + a breaker bar.

It will SAVE YOU ALOT OF strength =D Good luck.

-AzEKnightz


p.s. Sorry for double posting, the internet was acting weird and i clicked it twice...