Rear diff clearances
#2
imitek
Thread Starter
Found it (M) Front & Rear Axles https://www.rotaryheads.com/PDF/3rd_gen/
0.9mm to 0.11mm torque 73nm to 106nm
0.9mm to 0.11mm torque 73nm to 106nm
Last edited by imitek; 04-28-22 at 07:14 AM.
#4
imitek
Thread Starter
If you were having problems finding the pinon seal bd3063f there's few other numbers that are the same
BD3063F
0K710 27 238, 0K710-27-238, 95HCY-40751016C
51830-4E000
Seems to be regional found the 3rd number ending in 16c is available everywhere
BD3063F
0K710 27 238, 0K710-27-238, 95HCY-40751016C
51830-4E000
Seems to be regional found the 3rd number ending in 16c is available everywhere
The following users liked this post:
diabolical1 (05-01-22)
#5
imitek
Thread Starter
So make sure you get nsk bearings as other brands with same part numbers are not as tight of fit and made a solid pinon spacer as can't find anyone in UK that sells them 3 hours later lol so used the original crushed washer made it shorter in height and made rest of it thicker and tighter
Thread
Thread Starter
Forum
Replies
Last Post