Question: Engine rotor dimensions
#1
I rolled down a mountian
Thread Starter
Join Date: Mar 2003
Location: garden grove, california
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
Question: Engine rotor dimensions
Im getting quotes for some stock and need some rotor dimensions...
I need to know how much this little project of mine is going to cost me. If anyone cares im making billit titanium rotors for the 13b. The stock is going to be grade5 titanium
If your looking at the rotor standing upright and staring at the hole in the center, its the maximum width and height.
thanks a lot
-cheers
I need to know how much this little project of mine is going to cost me. If anyone cares im making billit titanium rotors for the 13b. The stock is going to be grade5 titanium
If your looking at the rotor standing upright and staring at the hole in the center, its the maximum width and height.
thanks a lot
-cheers
Last edited by geargrabber; 12-19-03 at 10:21 AM.
#4
Senior Member
you might want to check out the heat tolerances, and melting charastics of titanium. titaniumn isnt a very good metal to make anything thats going to withstand much pressure. and one of the first concerns i see with useing titanium is the apex springs will dig right into the metal of the rotor because titanium is so soft when compared to steel.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM