Purging and the feul lines
#1
Junior Member
Thread Starter
Purging and the feul lines
Hi I'm Matt, i have a 1987 rx7 fc with the 13b rotory. I want to know what a safe way to purge my fuel lines would be. I'm wanting to do this without dumping the muck from the line in the engine any suggestions?
#3
F'n Newbie...
iTrader: (6)
Or.... pull the return line from the tank and reroute if into a bucket, then jump the fuel pump from the diagnostic box in the bay. It'll run the pump while keeping the injectors closed and the engine off.
Its the same way you can test to see what your fuel pump is ACTUALLY flowing, it should absolutely work for purging any fuel currently in the lines.
Its the same way you can test to see what your fuel pump is ACTUALLY flowing, it should absolutely work for purging any fuel currently in the lines.
#4
Junior Member
Thread Starter
Thanks. I did want you guys suggested, by disconnecting the feul from to motor, ran out the bad gas. Upon cranking I do actually get some back fire so its an improvement. Now I think it is needs to crank faster.
#5
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Well if you ran the pump to get the gas out, you can now change the Sock on the pump and the main fuel filter.
Any fuel that you ran out of the system would contain crap that you didn't want in the system and would just hinder what you just did.
Any fuel that you ran out of the system would contain crap that you didn't want in the system and would just hinder what you just did.
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM