Purging and the feul lines
Hi I'm Matt, i have a 1987 rx7 fc with the 13b rotory. I want to know what a safe way to purge my fuel lines would be. I'm wanting to do this without dumping the muck from the line in the engine any suggestions?
Or.... pull the return line from the tank and reroute if into a bucket, then jump the fuel pump from the diagnostic box in the bay. It'll run the pump while keeping the injectors closed and the engine off.
Its the same way you can test to see what your fuel pump is ACTUALLY flowing, it should absolutely work for purging any fuel currently in the lines.
Its the same way you can test to see what your fuel pump is ACTUALLY flowing, it should absolutely work for purging any fuel currently in the lines.
Thanks. I did want you guys suggested, by disconnecting the feul from to motor, ran out the bad gas. Upon cranking I do actually get some back fire so its an improvement. Now I think it is needs to crank faster.
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
Well if you ran the pump to get the gas out, you can now change the Sock on the pump and the main fuel filter.
Any fuel that you ran out of the system would contain crap that you didn't want in the system and would just hinder what you just did.
Any fuel that you ran out of the system would contain crap that you didn't want in the system and would just hinder what you just did.
Thread
Thread Starter
Forum
Replies
Last Post
BLK 93
3rd Generation Specific (1993-2002)
11
Sep 9, 2015 10:56 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM






