PP/side port idea..
02-04-16, 02:16 AM
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Feb 2016
Location: Kowloon
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
PP/side port idea..
has anybody ever tried to incorporate side ports into a full sized peripheral port motor?.
i dont mean semi pp, more like semi Side Port with full P Port.the sides could be reduced by putting a small tube into the housing original port and sealing it up with devcon.
im thinking 3/4 inch ID and then straight into the pp port from both sides at 45 deg angle.This would help the dead areas?
Manny..
i dont mean semi pp, more like semi Side Port with full P Port.the sides could be reduced by putting a small tube into the housing original port and sealing it up with devcon.
im thinking 3/4 inch ID and then straight into the pp port from both sides at 45 deg angle.This would help the dead areas?
Manny..
