No injector pulse redux
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Apr 2004
Location: Charleston, SC
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
No injector pulse redux
A little while back, I converted the 13B in the Jensenator from an S5 ECU to an S4, so I could get rid of the electronic oil metering pump which will put the ECU into 'limp mode'. Once done, I had no injector pulse. I went over every connection and wire color code at least 5 times, no luck. I haven't had much time to mess with it until today and I yanked the whole harness, opened it up and traced.
All the wire connections were perfect- except one. The S5 and S4 FI setups use the same crank angle sensor, but the wiring is flipped from S4 to S5. It took a lot of head scratching and perusing of wiring diagrams to find this, but it now has injector pulse! Now all I have to do is put the harness back in and fire it back up. Hope this helps someone else.
All the wire connections were perfect- except one. The S5 and S4 FI setups use the same crank angle sensor, but the wiring is flipped from S4 to S5. It took a lot of head scratching and perusing of wiring diagrams to find this, but it now has injector pulse! Now all I have to do is put the harness back in and fire it back up. Hope this helps someone else.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM