Need help with technical terminalogy used
#1
Full Member
Thread Starter
Need help with technical terminalogy used
Please help? I have searched but have not found an explanation of terms used in this forum. Is there one?
The current term I have run into is "j-spec", I gather describing a particular gen II engine?????
I am exploring my options on an RX3 build project and have been recomended to get a j-spec then rebuild engine to my requirements for install into my RX3.
Any info???
And no I have no pictures of the car yet!
The current term I have run into is "j-spec", I gather describing a particular gen II engine?????
I am exploring my options on an RX3 build project and have been recomended to get a j-spec then rebuild engine to my requirements for install into my RX3.
Any info???
And no I have no pictures of the car yet!
#3
I live in an igloo
Join Date: Jul 2004
Location: calgary alberta
Posts: 2,546
Likes: 0
Received 0 Likes
on
0 Posts
Yea, you buy from a dealer that sells engines from JDM land, japan.
The engines are usually in good physical condition, as in no corrosion, etc. Most of them are not good internally though, and almost all of them need a rebuild as they'll have coolant/oil/apex seals that need to be replaced, thus the rebuild advice.
Atkinsrotary I believe gets these in, and rotaryengine.ca is also a good place for getting that. I've been told that rotary engine sells to atkins and landers, just a rumour.
The engines are usually in good physical condition, as in no corrosion, etc. Most of them are not good internally though, and almost all of them need a rebuild as they'll have coolant/oil/apex seals that need to be replaced, thus the rebuild advice.
Atkinsrotary I believe gets these in, and rotaryengine.ca is also a good place for getting that. I've been told that rotary engine sells to atkins and landers, just a rumour.