Mix and match with a TPS and pulling pins from the connector
Thread Starter
Attack Gas Station!!!!
Joined: May 2004
Posts: 1,081
Likes: 0
From: Catonsville, Maryland
Mix and match with a TPS and pulling pins from the connector
The full range is good on one TPS, and the half range is good on the other TPS.
I want to mix and match, but I am getting stuck where I need to pull the pins on the connector. I tried doing the "stick pin in the backside/top of the pin and pull" trick, but it did not seem to work. Any advice would be helpful.
Thanks in advance.
suds.
I want to mix and match, but I am getting stuck where I need to pull the pins on the connector. I tried doing the "stick pin in the backside/top of the pin and pull" trick, but it did not seem to work. Any advice would be helpful.
Thanks in advance.
suds.
Thread Starter
Attack Gas Station!!!!
Joined: May 2004
Posts: 1,081
Likes: 0
From: Catonsville, Maryland
Nevermind... I guess I was using the wrong size paperclip. I used the "jumbo" size and made a 90deg bend 1/8" from the end. Worked fine.
Thanks anyways dudes.
Thanks anyways dudes.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
86rxNa
2nd Generation Specific (1986-1992)
2
Aug 11, 2015 11:51 AM
