Mix and match with a TPS and pulling pins from the connector
The full range is good on one TPS, and the half range is good on the other TPS.
I want to mix and match, but I am getting stuck where I need to pull the pins on the connector. I tried doing the "stick pin in the backside/top of the pin and pull" trick, but it did not seem to work. Any advice would be helpful. Thanks in advance. suds. |
Nevermind... I guess I was using the wrong size paperclip. I used the "jumbo" size and made a 90deg bend 1/8" from the end. Worked fine.
Thanks anyways dudes. :) |
All times are GMT -5. The time now is 03:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands