Minimum o-ring groove depth
Thread Starter
Full Member
Joined: Jul 2006
Posts: 91
Likes: 0
From: Norway
Minimum o-ring groove depth
Hello!
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
Thread Starter
Full Member
Joined: Jul 2006
Posts: 91
Likes: 0
From: Norway
Hello!
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
Nobody knows? My many plates measure anything from 1.52-1.65mm.
