Minimum o-ring groove depth
02-09-16, 06:55 AM
#1
Full Member
Thread Starter
Join Date: Jul 2006
Location: Norway
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Minimum o-ring groove depth
Hello!
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
02-16-16, 04:54 AM
#2
Full Member
Thread Starter
Join Date: Jul 2006
Location: Norway
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Hello!
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
At topic, does anyone know how deep the groove is from Mazda, and how deep it must be minimum to allow the seal to seat the way it should?
I measure different depth on several of my plates, some I know have been lapped, but it would be good to know go/nogo measurements.
Thanks for any replies!
Stig
Nobody knows? My many plates measure anything from 1.52-1.65mm.