Innovative Wastegates
#1
Innovative Wastegates
I was wondering if anyone has experience in using their wastegates? I was looking at their Indy wastegate that is 51mm but started to think if it is possible to run two of their mini wastgates that are 38mm. Has anyone done a setup using two wastegates one for each exhaust runner? Pros and cons of this type of setup? And also how well do they hold up to the rotarys exhaust temps?
#2
Junior Member
Join Date: May 2008
Location: Patrick AFB, FL
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
I know this is an old thread but I'm having the same issue finding info about these wastegates. I just bought a 38mm for 125 shipped and I'm having issues finding info about it.
I had an innovative DBB 50 trim that was nice for what it was. Thats why I trusted this wastegate without knowing much about it.
I had an innovative DBB 50 trim that was nice for what it was. Thats why I trusted this wastegate without knowing much about it.
#3
Junior Member
Join Date: Mar 2009
Location: okinawa, Japan
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
This may be a little off topic but i have a 52mm HKS wastegate for sale that will hold up great against rotary heat if you change your mind on the twin 38mm...
Last edited by Blwn4wrd; 03-30-09 at 10:59 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM