How many engines have you blown this year?
#2
Super Raterhater
iTrader: (6)
Join Date: Dec 2001
Location: NY, MA, MI, OR, TX, and now LA or AZ!
Posts: 10,624
Likes: 0
Received 2 Likes
on
2 Posts
0. Impressive for the crazy stupid **** I do to them, amusing that people seem to blow them just by looking at them however, or people who go through 4 engines in one month, never did quite figure out that one.
#4
Senior Member
Join Date: Aug 2003
Location: Lancaster, PA
Posts: 631
Likes: 0
Received 0 Likes
on
0 Posts
1, didnt blow. but the seals where getting pretty worn (smoking for a little during start up) so i pulled her. im not sure if it really counts cause it still runs and has good compression
#5
I live in an igloo
Join Date: Jul 2004
Location: calgary alberta
Posts: 2,546
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Russ
1, didnt blow. but the seals where getting pretty worn (smoking for a little during start up) so i pulled her. im not sure if it really counts cause it still runs and has good compression
Trending Topics
#9
Moderator
iTrader: (7)
Originally Posted by SonicRaT
What in the world do you do to your rebuilds!?
Always learning the hard way. Engine was rebuild around november 2003, broken in on stock ECU, haltech E11V1 installed may 2004, blown during tuning, rebuild next day, broken in and blown again during tuning (7 days after first blew up). After that i took a break for about 20 days, went to Cyprus, borrowed E6K from George and after getting back home, rebuild it again, installed E6K and i am running on E6K now.
#11
2. First one blew driving it home from buying it. The guy did a poor rebuild, and the side seals siezed in the front rotar. Dropped in a used jspec, drove great for 2 months, blew a month ago. Apex seal failure from what I can tell. So I bought another jspec, with the intention of dropping it in, and driving the car while I rebuild the other one, but theis one has such a deep sratch on the housing near the exasut port I'm not going to chance it. I'm just rebuilding it now. Glad I have Mom's car to drive for a while!
#12
Full Member
Join Date: Jul 2004
Location: Fall River, MA
Posts: 202
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by syklone
2. First one blew driving it home from buying it. The guy did a poor rebuild, and the side seals siezed in the front rotar. Dropped in a used jspec, drove great for 2 months, blew a month ago. Apex seal failure from what I can tell. So I bought another jspec, with the intention of dropping it in, and driving the car while I rebuild the other one, but theis one has such a deep sratch on the housing near the exasut port I'm not going to chance it. I'm just rebuilding it now. Glad I have Mom's car to drive for a while!
#14
Originally Posted by nitrohaulik
Are you rebuilding these yourself?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM